As decided at the annual meeting, a tech session will be held at Doug Sjostrom’s home in Tewksbury, MA, on Saturday, April 26^th. The session will start at 10:00 AM with "Shrinking, Straightening & Dent Pulling" as the topic.

Various techniques for dealing with damaged panels will be covered. A handout compilation of the most helpful web sites for body restoration information will be available, or if preferred, participants may leave E-mail addresses and an e-file with hot links will be sent.

Work will be done on an MGA undergoing extensive sheet metal restoration.

Coffee and donuts will be served. Participants should bring safety glasses. 

The session will be held at 403 Trull Road in Tewksbury, MA. To get to 403 Trull Rd. from Rt. 495 take the route 38 off ramp and with the Home Depot on the right and a Volkswagen dealership on the right go half way up the hill and take the left at the stoplights. Less than a quarter mile there will be two left turns opposite a large crane hoist rental company.  Take the left marked Trull Rd which crosses over 495.  My place is just about a mile in from the Tree Service Co. It's the ranch on the right side opposite the only vacant lot on Trull Rd.